[Silver]

Originally Posted by donjohnson

All four of these where created with different airbrushs, same paint Golden Carbon Black straight out of the bottle. I penciled in some loops on each to give you some prespective. The four airbrushs where


Iwata BCS Eclipse - 0.5 mm needle, nozzle combination

Iwata HP-CS - .35mm needle, nozzle combination

Iwata Mircon B - .18 mm nozzle, needle combination

Sata 3 - 0.25 nozzle, needle combination



Tell me which airbrush created which panel?


This in response to all the questions we get about rendering fine lines, detail work and which airbrush is best. Can you tell the difference in the four examples I just posted, which airbrush was used?

I'm not asking for your opion which brand or model is best for detail, the airbrushs I used just happen to be handy it could have been a Badger 150, Passche VL these four airbrushs where just the airbrushs I had hooked up to my compressor when I did this.

I'm simply asking you to take a look at the example and by the size of the lines tell me which airbrush did which. All four have different size noozles, needles one is a bottom feed others are gravity feed.

The point I'm trying to make is its not the airbrush, nozzle or needle size, brand or model its the hand that controls the airbrush that renders the fine line or detail.

If i were to take a guess and all the lines were with the gun the same didtance away from the paper i would guess the .35=D .25=B .18=C .05=A Ihope i'm even close LOL Silver